July 15, 2020


If the printer is reset or the Clear 10 is received, the feed roller and platen are opened. A nearby magnetic source is interfering with the check reader. Back to home page Return to top. The slip is jammed. If the last bit is 0, the paper feed button is enabled. Ideally, an application will send all the data for an entire customer receipt without pausing between characters or lines transmitted. Switch 7 is always Off.

Uploader: Vudocage
Date Added: 11 February 2006
File Size: 53.56 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 7509
Price: Free* [*Free Regsitration Required]

This command is processed regardless of which station is selected. Any setting that exceeds the specified printing area is ignored.

Axiohm 7156 Owner’s Manual

On 01 1 Two-byte axihom code installed. You may select from any of the commands to program a host system to communicate with the printer.

In the event a condition causes the printer to go BUSY, it stops processing commands from the printer buffer. This command writes m bytes of data to the user data storage flash page at the address specified. Receipt station is selected Normal mode: Advance the axiojm if necessary by pressing the Paper Feed Button.

Standard and compressed pitches cannot be used together in the same line. MICR installed Not used. Receipt Station The receipt station centers characters standard pitch and compressed pitch and graphics on an 80 mm wide 3. Setup Guide Unpacking the Printer Save all packing materials in case you need to repack the printer.

  CR054G 009 DRIVER

Bits 1, 2, 3, 6, 7 are not used. Once this command is used — the case for a new application using multiple logos — the printer will no longer automatically erase the logo definition page when it fills with multiple definitions.

Axiohm Specifications |

Refer to eBay Return policy for more details. Host Flow Control Diagram Chapter 6: Set horizontal and vertical minimum motion units. In addition, there is no way to restart the printer after a paper jam, or to cancel a slip waiting condition when using the Wait for Slip command. DC1 11 17 Closes the feed roller and platen forms compensation arm assembly and retracts the forms arm stop unconditionally. Skip to main content. The user-defined characters are available until power to the printer is qxiohm off, an Initialize Printer command 1B 40 is received, or a downloaded bit image 1D 2A is defined.

The printer processes n bytes from the next character data as bar code data. Change the paper immediately. Any user-defined characters defined following this command will axiomh be preserved over power cycle. See the descriptions of the commands on page and The available options are: Two code pages will be printed.


The line spacing equals the character height when n is too small. ETB 17 23 Prints one line from the buffer and feeds paper one line.

The software utility can be used as provided or can be incorporated into your own application. Ordering Thermal Receipt Paper Press the On Line button to stop the test. Set the switches to the desired settings shown in the table.

If a slip is not inserted in the time specified, the receipt station is selected for the next function. This is only available in A Native Mode.

An application using these DLE 0x10 sequences and the original Clear Printer command 0x10 must distinguish for the printer between the new real time commands and the Clear Printer command by adding a NUL 0x00 to the Clear Printer command.